The power sliding door initialization procedure is a learning process for the module to identify the full open position and the full close position.
2000 ford windstar sliding door adjustment.
How to re align or adjust these things.
Here is a service bulletin that may help.
I can not find details on adjusting the stops sliders apparatus in this power sliding door mechanisms in the haynes manual.
There are roller guides on the top and the bottom of the door.
Make sure both power sliding doors are unlocked.
I ve also included the procedure for replacing the controller.
Competing against the chrysler minivans and the general motors apv minivans the front wheel drive villager was introduced between the ford aerostar and the ford windstar.
1999 2000 windstar issue on some vehicles the power sliding door may not react to a closing command from any of the power.
The next adjustment to the sliding door is to check the alignment of the c pillar striker with the door all the way in the closed position check the inboard outboard up down position of the striker to the latch.
Well there s always something needing fixing right.
Today it just happens to be the lock mechanism on the auto sliding door of the wife s minivan.
The mercury villager is a minivan that was marketed by the mercury division of ford.
View 10 replies similar messages.
The 2000 ford windstar has 11 problems reported for automatic sliding door stopped working.
Power sliding door adjustment dec 11 2008.
Make sure both power sliding doors are fully closed and latched.
Average repair cost is 1 900 at 108 550 miles.
Power sliding door does not close from the full open position vehicles built from 8 4 1998 through 10 1 1999 ford.
The striker should be sitting directly in the center of the latch for the up down position.
The ford windstar sliding passenger door has adjustments on the roller guides.
After power is restored to the vehicle initialize the sliding doors as follows.
Mine is not latching properly at the rear securing point 100 of the time.